Easy-on base coat ME by Mesauda
Low viscosity soak-off base. It adheres strongly to the nail surface and is easy to remove very quickly, leaving the nail clean and ready for a new application of semi-permanent varnish. Cures in 2 minutes in UV lamp or 1 minute in LED lamp.
Application :
- Opacify the natural nail with a polisher and remove the dust produced with a cellulose square soaked in ME Gel Remover . Apply Easy-bond acid-free primer by allowing it to air dry for 30 seconds.
- Apply a layer of Easy-on base and cure in UV lamp for 2 minutes or in LED lamp for 1 minute.
- Proceed with subsequent treatments according to the instructions.
Warning : Keep out of reach of children. Avoid contact with the skin. Irritating to skin and eyes. May cause skin sensitization. In case of contact with eyes: rinse immediately with water and consult a doctor. In case of ingestion: do not induce vomiting but seek medical advice immediately and show him the product.
Capacity : 4.5ML
Composition : ALIPHATIC URETHANE methacrylate, Isobornyl methacrylate, trimethylolpropane trimethacrylate, CELLULOSE ACETATE BUTYRATE, BUTYL ACETATE, ETHYL ACETATE, pentaerythrityl tetramercaptopropionate, trimethylbenzoyl diphenylphosphine OXIDE, BENZOYL ISOPROPANOL, ETHYL METHACRYLATE, A (T-BUTYL-benzoxazolyl) thiophene, BHT, CI 60725 / VIOLET 2.
- Type of nail products - Preparation product
- Outfit - Up to 15 days
- Nail salon capacity - 45 ml
- Type of nail care - Base
- Application - Application protocol reserved for professionals in the beauty sector due to substances contained in the product (European Regulation n°1223/2009)
