It is a protective base used with semi-permanent varnishes. It cures in 2 minutes under UV lamp (36 WATT) or in 1 minute under LED lamp (36 WATT). Duration up to 3 weeks, elimination in 15 minutes with Soak Off Remover.
more info
GEL POLISH Soak Off Base by Mesauda Milano . Gel Polish Soak Off Base is a specific protective base for use with gel polish. It cures in 2 minutes in UV lamp and in 1 minute in LED lamp. Up to 3 weeks of wear, removal in 15 minutes with Soak Off Remover.
Use 1. Disinfect the client's hand with the disinfectant solution. 2. Push back cuticles with the cuticle pusher. Thoroughly clean around the cuticles removing all residue. 3. Buff the entire surface of the nail plate with a white block. Carefully remove all dust produced with a suitable brush. 4. Apply Nail Prep and let air dry for 30 seconds. 5. Apply Ultrabond and allow to air dry for 30 seconds. 6. Apply Polish Soak Off Base gel, taking care not to touch the cuticles. Cure in a 36 WATT UV lamp for 2 minutes or 1 minute in a 36 W LED lamp and remove the sticky layer with a dry cellulose pad. If using a lower wattage source, cure for an additional 1-2 minutes. 7. Apply two thin coats of Gel Polish Gel and stick in each step in UV or LED lamp. 8. Apply gel polish base and top to seal the manicure, being careful not to touch the cuticles. Cure in 36 WATT UV lamp for 4 minutes or 2 minutes in LED lamp. 9. Remove the sticky layer with UV Gel Cleanser solution to finalize the job.
To remove 1. Use a 100/180 file to remove the shiny surface of the polish, being careful not to damage the natural nail. 2. Dip your fingers in the nail polish remover or apply a cotton ball soaked in remover to each nail, wrap it in aluminum foil and leave it on for 15 minutes. 3. Remove the swollen gel with a cuticle pusher.
Warning: Harmful if swallowed, irritating to eyes and skin, may cause sensitization by skin contact. Handle and open the container with care, avoid contact with skin and eyes. Wear suitable protective clothing and gloves. In case of insufficient ventilation, wear suitable respiratory equipment.
Application - Application protocol reserved for professionals in the beauty sector due to substances contained in the product (European Regulation n°1223/2009)
It is a protective base used with semi-permanent varnishes. It cures in 2 minutes under UV lamp (36 WATT) or in 1 minute under LED lamp (36 WATT). Duration up to 3 weeks, elimination in 15 minutes with Soak Off Remover.
